GE 369HIRM000E module
Technical data of product parameters
Providing synchronisation is enabled, the clocks in the devices
are synchronised to the PC clock by a broadcast telegram when
the remote HMI is started.
A genuine hardware handshake 369HIRM000E with the remote modem is not
possible in this mode and the DTR signal is therefore not set.
The modem handshake must be switched off and the DTR line
ignored. The line baud rate must not be higher than that of the
SPA-BUSThe exchange of data via a modem, SRIO etc., is appreciably
slower that the direct connection to the interface on the front of
the units. For this reason, a file called ReXX.dat is created every
time data are changed and saved together with the unit ID so
that the data of all the units do not have to be read every time
the HMI is started. XX is the unit’s SPA address. When the HMI
is started, it reads the units ID and searches for an ReXX.dat
with the corresponding ID in the current directory. Providing a
valid file is found, not all the remaining data in the unit are read.
The HMI uses the information in the ReXX.dat file and this
considerably shortens the time needed to establish 369HIRM000E
communication.
Since the unit data are not normally saved via the remote HMI,
the ReXX.dat files are not automatically available, but have to be
copied to the station’s directory after all the devices have been
finally configured.The main menu appears as soon as all the unit data areavailable.The main menu now includes the item ‘SPAComm’.tallation program creates all the directories needed and copies all the files to the hard disc. Program examples are to be
found on Disc 2.
The ‘Reporting’ installation program is on Reporting Program,
Disc 1. The installation program creates all the directories 369HIRM000E
needed and copies all the files to the hard disc. Program examples are to be found on Disc 2.
The ‘HMI RE-316*4 for SMS010’ installation program is on
SM/RE.316, Disc 1. The installation program creates all the directories needed and copies all the files to the hard disc. If
SMS010 is not in the default directory, a request appears to enter the directory where SMS010 is located. The program must be installed from a floppy drive.
Product picture display
Related products：
GE SR489-P1-HI-A20-E-H power module
Reviews
There are no reviews yet.