ABB IOR810 P-HB-IOR-80010000 energy speed controller
Technical data of product parameters
An AADvance controller is built from durable processor and I/O modules and
assemblies designed to IEC 61508 standards for safety systems and runs the IOR810 P-HB-IOR-80010000
AADvance Workstation software. Field devices connect direct to a controller
and external communication links over Ethernet and serial links use a secure
protocol.Each processor and I/O module has a flame-retardant and impact-resistant
plastic cover. The cover is designed to help ventilation and heat dissipation
occur naturally without the need for fan assisted cooling. Processor and I/O
modules fit onto standardized base units. Base units plug together by side
connectors and are securely held in position by specially designed plastic clips
which cannot corrode or seize up. Modules are retained by a locking screw
which is easy to access from the front.For each I/O Module there is a matched termination assembly. The controller
incorporates module polarization keying to make sure that they are correctly
mated when installed. Sockets on the rear end plate align and mate with
coding pins found on the termination assembly. The alignment of the sockets
and pins make sure that only the matched I/O modules and termination
assemblies can be mated.Each module carries a locking mechanism, which secures the module onto its IOR810 P-HB-IOR-80010000
base unit. The locking mechanism is in the form of a clamp screw, which can
be seen on the front panel of the module and engaged by a quarter turn of a flat
blade screwdriver. The module senses the locking mechanism position and
notifies the controller accordingly. This acts as an interlock device and helps
prevent the module from going on-line when it is not in the locked position.The power connections supply all three modules with redundant power, each IOR810 P-HB-IOR-80010000
processor module each have two Serial ports and two Ethernet port
connectors. The KEY connector supports all three processor modules and helps
prevent access to the application unless the Program Enable key is inserted.The serial ports (S1-1 and S1-2; S2-1 and S2-2; S3-1 and S3-2) support the
following signal modes depending on use:
• RS485fd: A four-wire full duplex connection that features different
busses for transmit and receive. This selection must also be used when
the controller is acting as a MODBUS master using the optional fourwire definition specified in Section 3.3.3 of the MODBUS-over-serial
standard.
Product picture display
Related products：
ABB SNAT4041 frequency converter
ABB SDCS-PIN-51 Governor Detection Board
Reviews
There are no reviews yet.